Spare Part: Sanding Belt for Abrasive Belt Holders SPIDER50 and SPIDER75
The sanding belt is designed as a spare part for the SPIDER50 and SPIDER75 abrasive belt holders. In case of wear, the existing sanding belt can easily be replaced with the appropriate version. Depending on the desired sanding result, sanding belts are available in grits 80, 120 and 220. The appropriate version can be selected for either the SPIDER50 or SPIDER75.
Available versions:
- SPIDER50, grit 80
- SPIDER50, grit 120
- SPIDER50, grit 220
- SPIDER75, grit 80
- SPIDER75, grit 120
- SPIDER75, grit 220
Grit: The lower the grit number, the coarser the abrasive. Grits 80, 120 and 220 cover different requirements for material processing – from coarse to fine sanding.
Safety Guard FAO for Milling Machines to Cover Tool Clamping
Movable locking protection for tool clamping covers for safe starting of your milling machine. This prevents the adjusting key from accidentally getting stuck when your milling machine is put into operation. The protection is supplied complete with an IP67 microswitch and is easy to install thanks to its pre-drilled flange. The integrated cap or cover is lifted and pushed away to allow the drawbar to be adjusted. Please check whether the height of the cover is sufficient for your milling machine. Scope of delivery: Interlock protection, safety switch, installation instructions, CE declaration of conformity
Abrasive Belt Guide SPIDER for Finishing Workpieces
Our safety belt sander for lathes "Spider" for the finishing of workpieces ensures safety. Most accidents on lathes occur during regrinding, polishing and removal of burrs. Designed according to DIN EN 23125 standards 6.2.1 (no use of hands during working operations), your hands no longer come close to rotating machine parts. Simple mounting The grinding belt holder Spider is quickly mounted on the tool holder of the lathe and is immediately ready for use. The grinding belt guide is pressed against the workpiece with the carriage, the hands of the operator are far away from danger points. A manually operated crank allows the abrasive belt to be turned further when worn. This also happens outside the danger zones. Note: the crank shown in the pictures only serves to transport the worn abrasive belt. The actual work is "done" by the tool slide. Work Facilitation By using the spider, you achieve a consistent sanding result. Depending on how close the tool slide comes to the workpiece, a uniform pressure is exerted on the workpiece to be machined. This is a tremendous improvement over the conventional and more dangerous manual method. Spare part: Abrasive belts Different belts (grain size, material) can be used according to your requirements. The belt can be changed quickly and easily: lift the lower tensioning spring, the abrasive belt relaxes and can be changed. Scope of delivery: Abrasive belt guide SPIDER in selected size, 3 abrasive belts in various grit sizes (grit 80 - 120 - 220), installation instructions, CE declaration of conformity